S-P-3648 $5,985.50
39" x 50" Inside Dimension
S-P-4896 $8,699.75
50" x 99" Inside Dimension
Note: S-P series are shipped completely set-up ready to run
and are equipped with a 8 CFM, 1 ATMOS., oil cooled rotary vane pump by
Busch which is designed to run "full time".
110Vac, 7 AMPS,
*Can be converted to 220Vac*
_________________________________________________________________________________________________________________________________________
FP-8400 $14,456.20
50" x 99" Inside Dimension
FP-10050 $18,529.50
63" x 123" Inside Dimension
Note: F series are shipped completely set up and factory
tested. A 16 CFM, 1 ATMOS, oil cooled rotary vane pump by Busch is
standard equipment, 220 Vac, single phase, 12 AMPS, 100 PSI @ 5 CFM is
required.
__________________________________________________________________________________________________________________________________________
FP/C 800 $29,529.50
50" x 99" Inside Dimension
FP/C 1000 $32,829.50
63" x 123" Inside Dimension
Note: FP/C series are designed to run at 75-80 degrees "C"
for fast cure of PVA and UREA adhesives in addition to others.
Heating is created by 2 convection type fans and 9000 watts of heating to
provide fast pre-heat times and even distribution of heat and fast cure
times. The membrane is .040 silicone resistant to 400+ degrees.
Vacuum is created with a Busch 16 CFM, 1 ATMOS, oil cooled rotary vane.
A 30 gallon receiver tank with a 1" dump valve for exceptionally fast
evacuation of the vacuum section of the press, 220 Vac, single
phase, 30 AMPS; air requirement is 100 PSI @ 5 CFM.
___________________________________________________________________________________________________________________________________________
FT-800 Thermofoil Press
$36,129.50
FT-800/M Thermofoil Press with Conversion Option
$41,299.50
FT-800/MCO Thermofoil Press Conversion Option Only
$5,142.50
